The rotary table of the positioner is characterized by simple operation and stable performance. The positioner can be manufactured according to the requirements of different manufacturers, so the overall actual operation is also designed and manufactured according to the regulations of the manufacturer, therefore, when the manufacturer is applied, it can better ensure the highefficiency of the manufacturing and the overall requirements, the maintenance is relatively simple, most of them are not prone to major common problems, and the application life is long. And in recent years, the positioner has also carried out reform and innovation, the new machine and equipment quality is stronger, the application is more stable, the operator as long as the actual operation is carried out in accordance with the reliable method, most of it is not easy to have any problems, although its characteristics are very good, but it is recommended that in the actual operation, let the relevant technical personnel actually operate, to ensure that the work is not easy to occur safety acciden

In the process of operation, it is necessary to pay special attention to some places, otherwise it will bring some unnecessary trouble in the process of use, but also cause some losses to itself, then what are the daily operation specifications of the rotary table of the positioner? Here is a brief introduction.

1. Comply with the company's (factory's) welder safety operation standard system.

2. When installing and disassembling the workpiece, check whether the ring fixture has been taken out and the fixture has been put back in place to prevent the workpiece from damaging the tool.

3. When lifting the workpiece, it must be stable and level, without large swing, to prevent the workpiece from colliding with the fixture, so as not to damage the tool.

4. When lifting the workpiece, the sling should be firmly installed before it can be removed from the workpiece.

5. When disassembling the workpiece, the workpiece should be lifted with a sling before it can be loosened.

6. When the workpiece falls on the fixture, it should be handled gently and cannot have too much impact on the welding fixture and welding positioner.

7. The workpiece installation should be positioned as required, all the nuts and bolts of the tool should be tightened, and the pressure plate should be pressed tightly. After the installation is complete, a trial operation check must be carried out to confirm the installation before the formal operation begins.

8. Before turning, check whether there are other items within the working turning range to avoid collision.

9. After the workpiece is transferred to the operating position, the power switch should be turned off to cut off the power supply to prevent misoperation.

10. The installation of the workpiece should pay attention to the center of the work, and must not deviate from the position of the heavy center.

11. No overweight, overload.

12. When the workpiece needs to ascend and weld, the ascent pedal should be used, and the ascent pedal should be placed safely before the ascent.

The above content is the daily operation specification of the rotary table of the displacement machine, and I hope it will be helpful to you